Ultra-Violet Systems

Aquamaster offers you a one – stop solution for all your ultra-violet-systems and sterilisation requirements.
Domestic or Commercial enquiries welcomed.

All of the ultraviolet systems are WRAS approved.
The 4-5 series ultraviolet systems are made from 316 stainless steel, and the 6 series is made from 304 stainless steel.

The image on the lefthand side is the 4 series ultraviolet system. The flow rates are from 4.4m3/hr to 8.4m3/hr.
The water connections come in 2" BSP male connections, with a pressure rating of 10 Bar.

The middle image is the 5 series ultraviolet system. The flow rates are from 11m3/hr to 19m3/hr.
The water connections come in 2" BSP male connections, with a pressure rating of 10 Bar.

The righthand image is the 6 series ultraviolet system. The flow rates are from 27m3/hr to 47.5m3/hr.
The water connections come in 4" BSP male connections, with a pressure rating of 10 Bar.

If you have a well water system that is supplying water to your property, there is the possibility that your water could contain harmful micro-organisms, including E-coli, Cyptosporidium, Giardia and Legionella. Some of these can not be eradicated by chlorination only...they need Ultra Violet disinfection.

There are also problems that can occur when your water is stored in a cold water storage tank. Some cold water storage tanks do not have proper lids to keep the water clean.

Ultra Violet systems offer an Environmentally- Friendly and chemical free way of purification. Your water will be free from taste and odour. Ultra Violet systems destroy ninety nine percent of bacteria. Whilst a glass of water may appear clear as you look at it,.... you can not actually see or tell whether it has any bacteria in it, as of course it is not visible to the naked eye. Ultra violet light systems will protect your whole water supply, and ensures that you will be protected against water born bacteria and viruses.

The typical life expectancy of an Ultra Violet light is 1 Year. It is also quite easy to change the bulb, normally the quartz sleeve will need cleaning either on a six-monthly or yearly basis....depending on the water quality.

STERILIGHT SILVER BASIC AND PLATINUM SP RANGE OF UV STERILISATION SYSTEMS.

Water quality is very important to get the optimum performance from your ultraviolet system.

The following water conditions and levels of requirement are required for your UV system to operate efficiently.

  • Iron:              <0.3 ppm (0.3 mg/L)
  • Hardness     <  7 gpg (120 mg/L)
  • Turbidity     <1 NTU
  • Manganese  <0.05 ppm (0.05 mg/L)
  • Tannins        <0.1 ppm (0.1 mg/L)
  • UV Transmittance :> 75%
  • Where water hardness is below 7 gpg, the uv should operate satisfactory, providing the quartz  sleeve is cleaned regularly.

If the water chemistry is higher then the above levels, a pre-water treatment system must be installed. If water hardness is above 7 gpg, ( 120mg/L ) a water softener will also be required.

We can supply and install ultraviolet systems from flow rates of 0.24 lts per hour to 9.50m3/hr

We can supply and design UV systems for swimming pools, large and small.